Free Shipping on All Orders

  Home > Powersports > STREET > Ducati Accessories >

2006-2010 Ducati SportClassic GT1000 Procom Powerjet 003

2006-2010 Ducati SportClassic GT1000 Procom Powerjet 003
2006-2010 Ducati SportClassic GT1000 Procom Powerjet 003


 
List Price: $129.00
Our Price: $119.95
You save $9.05!


Availability:: Usually Ships in 24 Hours - on all items (except made to order)
Product Code: 344432 F
Qty:

Description
 

2006-2010 Ducati SportClassic GT1000 Procom Powerjet 003 - SKU: 344432 F

Most fuel injected engines run very lean and this is fine except for when demanding maximum power output on the track, especially when you have sport exhausts installed. Being able to simply adjust the fuel/air ratio in those conditions would be wonderful wouldn't it?

The PowerJet Fuel Controller allows just that! You can adjust the fuel map from -4% to +10% by selecting one of the 10 settings. We even incorporated a stock setting which means no change compared to stock.

Procom PowerJet is a simple yet complicated device. It measures the outside air temperature very close to where the stock sensor is located, and adjusts the signal from the OEM air temperature sensor to the ECU to make use of the built in Air Temperature Correction factor that is built into every stock ECU.

What this accomplishes is that the ECU is told that the intake air is a little cooler than it is, and the ECU will respond by injecting a fraction more fuel depending on the PowerJet setting. You as a rider will notice a substantially improved engine response when you twist the throttle.

The neat thing is that when under constant load (constant speed) the oxygen sensor in the exhaust will make the ECU correct the fuel/air ratio back to stock! However, as soon as the system notices an increase in power it switches from closed loop (oxygen sensor feedback) back to open loop (no feedback) and will correct the fuel/air ratio by the amount you selected on the PowerJet.

PowerJet can be easily installed by plugging it in between the stock AIT sensor which is usually located somewhere on the airbox and the bike's wiring harness. Each PowerJet comes with the exact plug in connectors and installation will normally only take a few minutes. Finding the air temperature sensor usually takes more time than plugging in the PowerJet.

You can leave the PowerJet sitting under the bodywork somewhere as it is designed to be rugged and waterproof. After figuring out what setting works best with your specific engine/exhaust/intake combination you typically would leave it alone.

Fits:

Ducati Street Bikes

2007-2009 Ducati Hypermotard 1100 / 1100 S 
2007-2008 Ducati Monster 695 
2005-2007 Ducati Monster S2R 800 / S2RD 
2003-2006 Ducati Monster S4R 
2007-2008 Ducati Monster S4R / S4RS +Testastretta 
2006-2010 Ducati SportClassic GT1000 
2009-2010 Ducati SportClassic GT1000 Touring


Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Powersports > STREET > Ducati Accessories
Powersports > STREET